Declaring And Putting In Service Dect Base Stations; Declaring And Defining A Base Station - Aastra X series Installation And Implementation Manual

10.5 Declaring and putting in service DECT base stations

When declaring each base station note its position on the diagram (cabinet/card/channel).

10.5.1 Declaring and defining a base station

Use Menu 1.8.2.3 or Menu 1.9.2.3 to select the DECT base station you wish to put in service.
Three types of selection are proposed:
• By its equipment number in the cabinet.
• By the number of the trunk group to which the base station belongs.
• By the number of the cell to which the base station belongs.
When the selection is complete, the screen for defining the base station parameters is
displayed:
DEFINITION OF BASE STATION 0-02-02
• STATUS: This parameter indicates the current state of the base station.
• RAD.BASE TYPE: This parameter indicates the type of base station (2- or 4-channel).
• BELONGS TO TRUNK GROUP: This parameter indicates the name of the PBX trunk group
linked to the base station.
• MOBILE RECORDING ALLOWED: This parameter must be set to "YES" during mobile
registration if the base station is used for registration. When mobile registration is complete,
enter "NO" in this field to avoid fraudulent registrations. If the mobile registration procedure
fails, it is recommended to activate one or more neighbouring base stations during
registration.
Page 10-181
RADIO BASE SELECTION
BY EQUIPMENT NUMBER
OR BY ITS TRUNK GROUP
OR BY ITS CELL
STATUS IN SERVICE
RAD.BASE TYPE
BELONGS TO TRUNK GROUP
MOBILE RECORDING ALLOWED
FRAME TS 0->11 AFFECTATION
0->9 FREQUENCY ALLOCATION
- FREQUENCY NO. MODIF
ANTENNA SELECTION
SYNCHRONISATION ADDITIONAL PAIR SLAVE
DISTANCE FROM MASTER BS
TYPE OF BUS
10/2008
.....
.....
.....
DECT
..........
2 CHAN.
.FX0...
PAIRS
1111111111
AUTOMATIC
D < 100 METRES
SHORT
AMT/PTD/TR/0020/2/7/EN
NO
.