Chapitre 1 - Introduction; Item - Aastra X series Installation And Implementation Manual

1.1

Item

This document describes how to install and put in service the integrated DECT service for the
following PBXs:
NeXspan PBXs which correspond to iPBX earlier than R5.1
• NeXspan C/S/L/D
• NeXspan 50
• NeXspan 500
Aastra X series PBXs corresponding to iPBXs R5.1 and later
• Aastra XD
• Aastra XL
• Aastra XS, Aastra XS12 and Aastra XS6
This document is divided into 13 chapters:
Chapter 1: Introduction
This chapter gives the contents of the document, a list of the abbreviations used and the
definition of concepts specific to the DECT. Should you require more detailed information, a
"Reference Documents" section gives the references and titles of other manuals you can
consult.
Chapter 2: Description
This chapter describes the physical equipment making up the integrated DECT system (base
stations and mobiles).
Chapter 3: Deployment principles
This chapter describes the deployment method for a given installation, i.e. definition of the radio
coverage, the number of base stations and the dimensioning of the system.
Chapter 4: Implementation of hardware on NeXspan C/S/L/D
This chapter describes the interface cards to be used in a NeXspan C/S/L/D and the wiring
layout between the device and the DECT base stations.
Chapter 5: Implementation of hardware on Aastra X series
This chapter describes the interface cards to be used in AXD, AXL, AXS, AXS12 and AXS6
devices, and the wiring layout between the device and the DECT base stations.
Chapter 6: Implementation of hardware on NeXspan 50
This chapter describes the interface cards to be used in a NeXspan 50 and the wiring layout
between the NeXspan 50 and the DECT base stations.
Chapter 7: Implementation of hardware on NeXspan 500
This chapter describes the interface cards to be used in a NeXspan 500 and the wiring layout
between NeXspan 500 and the DECT base stations.
AMT/PTD/TR/0020/2/7/EN
Chapter 1 - Introduction
10/2008 Page 1-12