Sanyo Denki PE Series Installation And Operation Manual page 26

Connecting the
Load to the Motor
PE Manual
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
x
Slacken the cable outside the cover and provide a cable trap so that oil and water may
not travel up the cable.
Seal with a gasket
Cover
x
If an oil-filled gearbox is used, make the oil level of the gear box lower than the oil
seal lip. Provide a vent in the gearbox to prevent internal pressure in the gear box
from rising and forcing oil into the motor.
External Diameter
of the Shaft
Oil Level
The mechanical connection between the motor and the load is critical. An improper
connection can limit performance and shorten the life of the motor.
x
Perform centering accurately between the motor shaft and the load as shown in the
figure below. Note that with a rigid coupling, a slight offset will lead to damage of
the output shaft.
Copyright © 2000 Automation Intelligence, Inc.
Do not let cables touch any
water or oil reservoir
Gear
Oil Seal Lip
26
Issued: 27-Apr-00