Sanyo Denki PE Series Installation And Operation Manual page 15

Set Key
Parameters
Jog Operation
PE Manual
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
Motor Type
1. Turn ON the control power, the 230Vac attached to the r and t terminals. The
power LED should turn ON and a dash should appear in the middle of the 7-segment
display.
x
The remote Operator Screen should display the [Push Mode Key] screen
and a beep should sound.
2. Enable System Parameter changes using the Remote Operator.
x
Press [ON / Mode] and
\
x
Press the key until you have switched to page 13 where you can set the
Func3 parameters.
ì
x
Press the key to change bit 7 to a 1.
x
Press the [WR] key to save the change.
3. Set the motor type.
x
Press [ON / Mode] and
\
x
Press the key until you have switched to page 9 where you can set the
motor type parameters.
[
x
Press the and
x
Press the [WR] key to save the change.
x
Cycle the control power supply OFF and back ON.
1. To simplify wiring for this Inspection Test, the overtravel limits will be set for
normally open limit switches.
x
Press [ON / Mode] and
Z
x
Press the and
interface functions.
[
x
Press the key twice and the
x
Press the [WR] key.
2. Enable Test mode operation using the Remote Operator. Jogging and Auto-tuning
are in the test mode.
Copyright © 2000 Automation Intelligence, Inc.
í
to enter the parameter set mode.
ì
to enter the parameter select mode.
]
keys to change to the proper type.
í
to enter the parameter set mode.
\
keys to switch to page 10 where you can set the user
ì
key once to change bit 5 to a 1.
15
Issued: 27-Apr-00