Initial Inspection; Switch And Jumper Settings; Base I/O Address (Sw1) - Advantech PCL-833 User Manual

Initial inspection
In addition to this manual the shipping container should contain the
PCL-833 card and a utility diskette. We carefully inspected the PCL-
833 mechanically and electrically before we shipped it. It should be
free of marks and scratches and in perfect electrical order on receipt.
As you unpack the card, check it for signs of shipping damage
(damaged box, scratches, dents, etc.). If it is damaged or fails to meet
its specifications, notify our service department or your local sales
representative immediately. You will need to contact the carrier so that
it can inspect the shipping carton and packing material. We will then
arrange to repair or replace the unit.
Remove the PCL-833 interface card from its protective packaging
carefully. Keep the antistatic package. Whenever you are not using the
board, please store it in the packaging for protection.
Warning! Discharge any static electric charge on your body by

Switch and jumper settings

DIP switch SW1 sets the card's I/O address and jumper JP1 sets the
card's interrupt level.

Base I/O address (SW1)

The PCL-833 requires 16 consecutive I/O addresses. DIP switch SW1
(shown below) sets the base I/O address.
8 PCL 833 User's Manual
touching grounded metal before you handle the
board. You should avoid contact with materials that
create static electricity such as plastic, vinyl, and
styrofoam. Handle the board by its edges to avoid
contacting the board's integrated circuits.
O N
1 2 3 4 5 6