Table of Contents
Advertisement
OPERATOR'S SECTION
4.11. CONFIG DISPLAY - This section configures the data that will be displayed on the screen.
4.11.1. SHOW LOAD? - YES arrow "UP", NO arrow "DOWN". Press "OK" to confirm.
4.11.2. SHOW HIGH? - YES arrow "UP", NO arrow "DOWN". Press "OK" to confirm.
4.11.3. SHOW HOIST? - YES arrow "UP", NO arrow "DOWN". Press "OK" to confirm.
4.11.4. SHOW RADIUS? - YES ARROW "UP", NO arrow" DOWN". Press "OK" to confirm.
4.11.5. SHOW LENGTH? - YES arrow "UP", NO arrow "DOWN". Press "OK" to confirm.
4.11.6. SHOW ANGLE? - YES arrow "UP", NO arrow "DOWN". Press "OK" to confirm.
4.11.7. SHOW REEVING? - YES arrow "UP", NO arrow "DOWN". Press "OK" to confirm.
4.12. CONFIGURATION READY??? - At this point, you may return to any part of the calibration
sections by using the arrows "UP" or "DOWN" to change calibration data. Press "OK" to
confirm.
4.13. SAVE TO E-EPROM??? - Save calibration data to E-Eprom by pressing "OK". Pressing the
arrow "DOWN" for NO will disregard data entries made during this calibration session. If
the calibration data is disregarded and the system has not been calibrated as stated in this
document and the crane must not be operated.
4.14. The screen then changes to the operating configuration which is presently set. Turn power
off for 10 seconds.
4.15 Turn power on. The display shows the crane configuation which is presently set.
4.16 Press 'OK'. The display shows the normal operating screen, but the main boom length,
height, and radius are displayed as zero (0.0).
4.17 Press the "Select" button. The 'Select' button enters the operating configuration.
4.18 Press the "OK" button to select the boom.
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99
35
Advertisement
Table of Contents
