Table of Contents
Advertisement
32
4.8.4. LENGTH_2 MAX - Press the arrows "UP or "DOWN" to display "0". Press "OK" to
enter length.
4.8.5. OFFSET MIN - Press the arrows "UP or "DOWN" to display minimum offset angle.
Press "OK" to enter angle.
4.8.6. OFFSET MAX - Press the arrows "UP or "DOWN" to display maximum offset angle.
Press "OK" to enter length.
4.8.7. WHIP EXTENSION - Press the arrows "UP or "DOWN" to select NO and Press "OK"
to confirm entry.
4.9. CONFIGURE KMD1 - This step calibrates the main hoist force sensor. To calibrate this
section you will be required to pick a know test load 80% of permissible line pull. Check the
linerider output voltage, see section 3.4.1.
4.9.1. Press "OK" to calibrate the KMD1 - Main Linerider or press the arrow "DOWN"
button to continue.
4.9.2. PARTS OF LINE - Use the arrows "UP or DOWN" to select parts of line. NOTE: One
part of line should be used to calibrate a Line Rider.
4.9.3. KMD1 TYPE - Use the arrows "UP or DOWN" to enter the value for the "KMD TYPE"
listed on Table 3.
Table 3. KMD Type values for Link-Belt wire ropes
WIRE ROPE SIZE
7/8"
1"
For the SKM500, the KMD TYPE value equals the maximum hoist rope line pull
divided by 2,204 and round up to the next whole number. (i.e. 29,500lbs. Line pull
divide 30.5 by 2.204 = 13.4, rounded up = 14. The KMD TYPE value is 14.)
4.9.4. Press "OK" to confirm KMD type.
EI65 OPERATOR'S AND CALIBRATION MANUAL
LINK-BELT ROPE TYPE
M
N
P
-
11
6
-
14
8
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99
LB
RB
DB
12
8
11
15
11
14
Advertisement
Table of Contents
