Table of Contents
Advertisement
EI65 Operator's and Calibration Handbook
CALIBRATION SECTION
1 GENERAL INFORMATION
The Length-Angle-Radius-Load Indicating System EI 65 must be calibrated after completing
installation, crane modification, or anytime there is an indication of inaccuracy. The calibration
will match the installed sensor to the crane. Refer to the Installation Handbook for the system
and sensor installation.
Prior to starting the calibration, it is advised to first read over this procedure in its entirety. This
will also allow you a chance to obtain any necessary information. The purpose of this handbook
is to provide calibration information required before operating the system. Refer to the
Operator's Section of this Handbook for system description and console controls.
2 WARNINGS
Always refer to operational instructions and load charts provided by the crane manufacturer for
specific crane operation and load limits.
The Length-Angle-Radius-Load Indicating System EI 65 is not and shall not be a substitute for
good operator judgment, experience, or use of acceptable safe operating procedures.
The operator is responsible for operating the crane within the manufacturer's specified
parameters.
The crane operator shall ensure that all warnings and instructions provided by the manufacturer
are fully understood, observed, and remain with the crane.
Prior to operating the crane, the operator must carefully read and understand the information in
the Operator's Handbook so that he knows the operation and limitations of the Length-Angle-
Radius-Load Indicating System EI 65.
Always follow the manufacture's guidelines when operating the crane.
Always work within the capacity of the rated load charts provided by the manufacturer.
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99
Advertisement
Table of Contents
