10
STEP 4
BOOM LGTH?
PUSH ↓↑ OR OK
To enter a new main boom length, the operator has to select the value by pushing the
buttons "UP" (12) or "DOWN" (11).
Go to Step 10 HOIST SELECT.
STEP 5
JIB SELECT?
PUSH ↓ OR OK
Push Button "OK" (10) for next step.
If the operator wants to continue with the previously programmed jib configuration or the
default values he has to push the button "DOWN" (11).
STEP 6
JIB LGTH_1:
45
PUSH ↓↑ OR OK
To enter a new jib length, the operator has to select the value by pushing the buttons "UP"
(12) or "DOWN" (11). If no jib 1 is used the value 0.0 has to be selected.
If the operator wants to continue with the displayed length of jib 1 he has to confirm by
pushing the button "OK" (10).
Push Button "OK" (10) for next step.
Note: Jib 1 is a boom extension with fixed length and without offset angle.
STEP 7
JIB LGTH_2:
25
PUSH ↓↑ OR OK
To enter a new jib length, the operator has to select the value by pushing the buttons "UP"
(12) or "DOWN" (11). If no jib 2 is used the value 0.0 has to be selected.
If the operator wants to continue with the displayed length of jib 2 he has to confirm by
pushing the button "OK" (10).
Push Button "OK" (10) for next step.
EI65 OPERATOR'S AND CALIBRATION MANUAL
The display shows the previously programmed or default length of the
main boom.
The operator is requested to enter the jib configuration.
To enter new jib data, push the button "OK" (10).
The display shows the previously programmed or default length of jib
1.
The display shows the previously programmed or default length of the
jib 2.
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99