Table of Contents
Advertisement
OPERATOR'S SECTION
9
Button "Tare"
The button "Tare" (9) is used to indicate the net load on the display. Net load is
the actual load, less lifting tackle and hook block. The button "Tare" has to be
T A RE
activated before lifting.
After pushing the button "Tare" (9) before lifting the load display will be set to
zero (tare) and the lamp in the button lights up. After lifting a load the load display shows the
net load (pay load).
The net load display will return to the normal load display when the button "Tare" (9) is
pressed a second time.
10
Button "OK"
This button (10) is used to confirm values and data which are used as input for
the system. The instruction to use this button will always be given on the
OK
display.
11
Button "Down"
The button "Down" (11) is used to get an decrease of a numerical value at the
display during the programming and setting procedures and to move through
the different menus in "Down"-direction. The instruction to use this button will
be given on the display.
12
Button "Up"
The button "Up" (12) is used to get an increase of a numerical value at the
display during the setting procedure of limits and operating conditions.
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99
7
Advertisement
Table of Contents
