PAT EI 65 Operator's Manual page 24

18
EI65 OPERATOR'S AND CALIBRATION MANUAL
Setting of Load Limit
STEP 1
This message appears after pushing the Button "LIMIT" (8). For activating the Setting
Procedure of Load Limit the operator has to push Button "DOWN" (11) four times to skip the
length, angle, radius and height preset setting procedure.
Push Button "DOWN" (11) 4 times for next step.
STEP 2
To select the Load Preset Programming Procedure push the button "OK" (10).
Push Button "OK" (10) for next step.
To skip the load preset limit push the button "DOWN" (11).
Step 3 to 4 will be skipped, when the Button DOWN is pressed.
STEP 3
The actual value of the Maximum Load Preset is displayed.
To enter a new value of the Maximum Load Preset, the operator has to push the button "UP"
(12) for increase and the button "DOWN" (11) for decrease the displayed value.
If the crane operator wants to continue with the displayed value, he has to confirm by
pushing the button "OK" (10).
Push Button "OK" (10) for next step.
STEP 4
The Setting Procedure for the Load Presets is completed. The display shows the actual crane
data.
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99