PAT EI 65 Operator's Manual page 25

OPERATOR'S SECTION 19
Deactivation and Cancellation of Limits
STEP 1
This message appears after pushing the Button "LIMIT" (8). For activating the Setting
Procedure of Load Limit the operator has to push Button "DOWN" (11) five times to skip the
length, angle, radius, height, and load preset setting procedure.
Push Button "DOWN" (11) 5 times for next step.
STEP 2
To select the Deactivation and Cancellation of Limits Procedure push the button "DOWN"
(11).
Push Button " DOWN" (11) for next step.
To return to the normal data display push the button "OK" (10).
STEP 3
For deactivation and cancellation of the previously programmed limits the operator has to
push the button "OK" (10). In this case the system sets all limits on their default values. The
Load Limit and Maximum and Minimum Angle Limit are active. All other limits are deactivated.
The Deactivation and Cancellation Procedure for the limits is completed. The display shows
the actual crane data.
Push Button "OK" (10) for next step.
After pushing the button "DOWN" (11) the system returns to the begin of the procedure
Activating and Setting of Preset Limits.
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99