Table of Contents
Advertisement
OPERATOR'S SECTION
Note: Jib 2 is an extension with fixed length and with different offset angles.
STEP 8
JIB OFFSET_2:
15
PUSH ↓↑ OR OK
To enter a new offset angle, the operator has to select the value by pushing the buttons "UP"
(12) or "DOWN" (11).
If the operator wants to continue with the displayed offset angle of jib he has to confirm by
pushing the button "OK" (10).
Push Button "OK" (10) for next step.
STEP 9
MAIN BOOM?
PUSH ↓ OR OK
Confirm jib values entered in Steps 6 to 9, by pressing the button "OK".
STEP 10
HOIST SELECT?
PUSH ↓ OR OK
The crane operator is requested to enter the actual hoist winch.
Push Button "OK" (10) for next step.
If the operator wants to continue with the previously used or default hoist he has to push
button "DOWN" (11).
Step 11 will be skipped, when the button "DOWN" is pressed.
STEP 11
MAIN HOIST?
PUSH ↓ OR OK
AUXILIARY HOIST?
PUSH ↓ OR OK
STEP 12
REEVING?
PUSH ↓ OR OK
The previously programmed or default offset angle of jib 2 is
displayed.
If the main boom length is correct, push the button "DOWN" (11). To
change the main boom length the button OK (10) has to be pressed.
Step 11 will be skipped, if the crane is not equipped with an Auxiliary
Hoist.
To select either the Main Hoist or the Auxiliary Hoist the operator
has to use the button "DOWN" (11).
If the operator wants to continue with the displayed hoist he has to
confirm by pushing the button "OK" (10).
Push Button "OK" (10) for next step.
The crane operator is requested to enter the number of reevings
(parts of line) being used.
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99
11
Advertisement
Table of Contents
