Table of Contents
Advertisement
OPERATOR'S SECTION
15
Setting of Boom Radius Presets
STEP 1
This message appears after pushing the Button "LIMIT" (8). For activating the Setting
Procedure of Boom Radius Limits the operator has to push Button "DOWN" (11) two times to
skip the Length and angle preset setting procedure.
Push Button "DOWN" (11) two times for next step.
STEP 2
To select the Boom Radius Preset Programming Procedure push the button "OK" (10).
Push Button "OK" (10) for next step.
To skip the radius preset limit push the button "DOWN" (11).
Step 3 to 6 will be skipped, when the Button DOWN is pressed. The system continues with
Height Limit Preset Programming Procedure (see Section 4.3.3)
STEP 3
The actual value of the Minimum Boom Radius Preset is displayed.
To enter a new value of the Minimum Boom Radius Preset, the operator has to push the
button "UP" (12) for increase and the button "DOWN" (11) for decrease the displayed value.
If the crane operator wants to continue with the displayed value, he has to confirm by
pushing the button "OK" (10).
Push Button "OK" (10) for next step.
STEP 4
The actual value of the Maximum Boom Radius Preset is displayed.
To enter a new value of the Maximum Boom Radius Preset, the operator has to push the
button "UP" (12) for increase and the button "DOWN" (11) for decrease the displayed value.
If the crane operator wants to continue with the displayed value, he has to confirm by
pushing the button "OK" (10).
Push Button "OK" (10) for next step.
L-B B5L0082/PAT 031-300-190-015 REVISION D 04/15/99
Advertisement
Table of Contents
