I/O Specification - Toshiba teli BC Series Instruction Manual

I/O Specification

● Signal Specification
● Line4 (GPIO Output, I/O connector, 1pin)
Signal level:
Maximum current:
Signal Polarity:
Ouput signal:
● Line5 (External Trigger Input, I/O connector, 4pin)
Input circuit:
Signal level:
Signal Polarity:
Pulse width:
Notes of external trigger signal:
- Depending on cable length, kind of cable and input current of trigger input line, external trigger signal may not be
accepted by camera.
- Line5 and Line6 have a different input level. Please use input level within the voltage described in this specification.
may not receive EXT_TRIG signal. Please confirm it before use.
Copyright © 2016-2018 TOSHIBA TELI CORPORATION, All rights reserved.
5V CMOS
+/- 32mA
(drive current)
Factory setting: Low active (it is possible switching by camera settings)
TIMER0 ACTIVE
USER OUTPUT
EXPOSURE ACTIVE
FRAME ACTIVE
FRAME TRANSFER
FRAME TRIGGER WAIT
LVTTL
Low 0 to 0.5V、High 2.0 to 24.0V
Factory setting: Low active (it is possible switching by camera settings)
50 s (minimum)
μ
23 / 69
D4272607A
http://www.toshiba-teli.co.jp/en/index.htm