Netvanta 6360 Front Panel Design; Figure 2. Netvanta 6360 Front Panel Layout - ADTRAN NetVanta 6360 Hardware Installation Manual

Physical Description

NetVanta 6360 Front Panel Design

The NetVanta 6360 front panel is shown below along with a description of all connectors and interfaces.
NetVanta 6360
10/100/1000Base-T Ethernet Interfaces
The port consists of one SFP slot for connectivity over fiber. The status LED is located above
GIG 0/1
the interface.
The ports consist of one RJ-45 and one SFP slot for connectivity over fiber. (Use either the
GIG 0/2
RJ-45 connector or the SFP slot. The fiber slot has precedence.) The status LED is located above the
SFP slot.
The through
GIG 0/3
for the Ethernet interface pinouts.
CONSOLE Interface
The interface is an EIA-232 serial port (DCE), which provides for local management and
CONSOLE
configuration (via a DB-9 female connector). See
pinouts.
Connection directly to an external modem requires a cross-over cable.
USB Interface
The interface is Type A USB host connector and is provided for use with 3G/4G modems or flash
USB
drives. The status LED, labeled
Status LEDs
The LED indicates the unit's status; the
STATUS
network module; the
status of the USB interface; the
1 and T1/E1 2 LEDs reflect the status of the T1/E1 interfaces. See the table below for LED behaviors.
See Table 1 on page 19
18
G G I 0 1 / G G I 0 2 / G G I 0 3 / G G I 0 4 /

Figure 2. NetVanta 6360 Front Panel Layout

ports are RJ-45 for connectivity over copper. See
GIG 0/5
, is located on the right front panel.
USB
LED indicates the status of the EFM groups; the
EFM
VOICE LED indicates the status of the voice connector, and the
for LED behaviors.
Copyright © 2014 ADTRAN, Inc.
NetVanta 6360 Hardware Installation Guide
G G I 0 5 /
CONSOLE
USB
Table A-1 on page 41
LED indicates the status of the installed
MODULE
STATUS
MODULE VOICE
EFM T1/E1 1
USB T1/E1 2
Table A-3 on page 42
for the interface
CONSOLE
LED indicates the
USB
T1/E1
617006364F1-34A