Configuring An M92X Mobile Terminal - Aastra NeXspan C Installation Manual

2.5.2 Configuring an M92x mobile terminal

Registering an M92x mobile terminal
A. Check that the mobile has not already been registered.
The cordless handset must not contain any "parasite" registrations (for example, from previous
use on another DECT system). In the standard case where the mobile is to be used on one
DECT system only, it must not be registered on any other base at the outset.
• At startup, if the mobile displays:
it is not currently registered on any other base. Press the
and proceed to step 6 under paragraph B).
• If the mobile displays:
it is already registered on at least one other base.
1 Press the
2 Press the middle
3 Press the Select base : key
• Any base numbers already in use are displayed. These numbers must be de-registered
on the mobile.
B. Register the mobile on a base
1 Press the
2 Enter the installer code 9995.
3 Press the middle key
4 Press the Declare key
The display shows: "Declare base no. 1 2 3 4 5 6 7 8".
5 Press the
6 "Enter code" appears on the display
Enter the "set number + PBX registration code" and press OK
The set displays "Please Wait".
• "Still waiting"
• "Declare base OK" or "Failed, Retry"
Stop and restart the mobile, then check to see if it is active.
AMT/PTD/PBX/0020/2/4/EN
Declare
base number?
1 2 3 4
Delete base n
no
Menu key
key until "Select base" is displayed
Menu key
or several times until "Declare" is displayed
or key to select base 1, 2, 3, 4, 5, 6, 7 or 8. Confirm with the OK key.
01/2007
OK
OK key
yes
.
Page 47