Rcl; Rst; Sav - ITech IT8500+ Series Programming Manual

*RCL

This command restores the electronic load to a state that was previously stored
in memory with a *SAV command to the specified location. All states are
recalled with the following exceptions:
CAL:STATe is set to OFF
The trigger system is set to the Idle state by an implied ABORt command (this
cancels any uncompleted trigger actions)
NOTE: The device state stored in location 0 is automatically recalled at power
turn-on.
Command Syntax
*RCL <NRf>
Parameters
0 to 9
Examples
*RCL 3
Related Commands
*PSC

*RST

This command reset the electronic load to the factory-defined states.
Command Syntax
*RST
Parameters
None

*SAV

This command stores the present state of the electronic load to a specified
location in memory. Up to 100 states can be stored. If a particular state is
desired at power-on, it should be stored in location 0. It then will be recalled at
power-on if the power-on state is set to RCL0. Use *RCL to retrieve instrument
states.
Command Syntax
*SAV <NRf>
Parameters
0 - 99
Examples
*SAV 3
*RST *SAV
Copyright © ITECH Electronic Co., Ltd.
IEEE488 Commands
69