Install Inside Lever With Dowel Screw (All); Full Dummy Trim (Tl3770) & Half Dummy Trim (Tl3750) Installation; Insert Dummy Spindle (All) - Assa Abloy Corbin Russwin TL3700 Series Installation Instructions Manual

TL3700 Series
Designer Trim
Installation Instructions
1 Full-Trim (TL3710 & 3720) & Half-Trim (TL3780) Installation (cont .)
l

Install Inside Lever With Dowel Screw (All)

1. Install Lever.
2. Rotate lever and make sure it returns. If lever binds, remove inside lever and un-thread adjustment
bolt 1/2 turn.
2 Full Dummy Trim (TL3770) & Half Dummy Trim (TL3750) Installation
a

Insert Dummy Spindle (All)

Insert dummy spindle into adapter plate.
• TL3770 use both adapter plates.
Note
Make sure dummy spindle is aligned.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2011, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Make sure hole in
adjustment bolt
is aligned with
threaded hole in
inside lever.
1/16"
After dowel screw is installed
there should be less than 1/16"
clearance between adapter
plate and shoulder on lever.
Figure 12
Figure 13
7
FM341 07/19