Table of Contents
Advertisement
Chapter 4
7
Installing additional expansion modules
Prerequisites
•
You need one 10-pin cable for each expansion module you want to install.
•
You need one foot stand for each expansion module you want to install. Not required
for wall-mounted applications.
Procedure steps
Step
1
2
3
4
5
6
7
Press the expansion module and IP Phone firmly together until the expansion
module locks into place.
CAUTION
Risk of damage to equipment
To avoid damaging the equipment, remove the power (PoE cable or local
power) from the IP Phone before you connect the expansion module.
Action
Remove power from the IP Phone and existing expansion module.
Remove the IP Phone and expansion module from the foot stand.
At the back of the first expansion module attached to the IP Phone, on the
right side, remove the rubber plug from the AEM port.
Plug the 10-pin cable into the AEM port on the first expansion module.
Place the connecting arm of the next expansion module behind the first
expansion module.
Align the connecting tabs of the second expansion module with the
connecting slots on the back of the first expansion module.
Repeat steps 1 through 6 for each subsequent expansion module you add.
End
End
IP Phone 1200 Series Installation
33
Advertisement
Table of Contents
