Installing The Expansion Module - Nortel 1100 Series User Manual

Installing the Expansion Module

Use the following instructions to install the Expansion Module.
1. Press the tilt lever to adjust the stand angle on the IP Phone. You can adjust
the stand angle to maximum, instead of removing the stand. See Figure 2.
CAUTION
Damage to Equipment
To avoid damaging the equipment, remove the
power (PoE cable, or local power) from the IP
Phone before connecting the Expansion
Module.
CAUTION
Damage to Equipment
The Expansion Module is shipped with the
base locked in position. To avoid damaging the
Expansion Module, press the tilt lever, located
on the base at the front of the
Module.
Setup and assembly
Expansion
Wall Mount Lever
11