Table of Contents
Advertisement
28
Connecting the power (optional)
Your IP Phone supports both AC power and Power over Ethernet (PoE). For AC power, use
only the Nortel-approved Global Power Supply (N0146475) and the country-specific IEC cable
that you can order separately. To use PoE, your connected LAN must support PoE.
Procedure steps
Step
1
2
3
Connecting the LAN Ethernet cable
Connect your IP Phone to your LAN using an Ethernet cable to enable full functionality of your
IP Phone. If your Ethernet port is equipped with Power over Ethernet (PoE), your IP Phone can
be powered through the LAN port. Do not extend the LAN Ethernet cable outside the building.
Procedure steps
Step
1
2
3
NN40050-302
Action
Connect the DC barrel connector to the power jack on the back of the
IP Phone.
Thread the cable through the channel in the foot stand to secure the cable.
Plug the country-specific IEC cable into the Global Power Supply, and then
plug the Global Power Supply into the nearest AC power outlet.
Action
Plug one end of the supplied LAN Ethernet cable into the LAN Ethernet port
on the back of your IP Phone marked with the
Thread the cable through the channel in the foot stand.
Connect the other end of the cable to your LAN Ethernet connection.
The LAN LED on the back of the IP Phone lights when a LAN connection is
established.
End
symbol.
%
End
Chapter 3
Advertisement
Table of Contents
