Advertisement
9. Pull on the locking pin that is located through the access door, above the card cage intake fan.
10. Slide the card cage out along the guides.
To avoid possible damage, carefully place the card cage on a clean, flat surface.
Cleaning optics (excluding lens)
Unnecessary cleaning of optics can be more harmful than helpful by increasing the risk of damage to
delicate coatings and surfaces.
Only clean optics when dust, dirt, oil, fingerprints or other marks are obvious or are the cause of
performance problems. Maintenance of optical components requires a qualified service technician.
Inspect exposed optical surfaces periodically in a clean, dust-free environment using a flashlight.
Always wear appropriate gloves when servicing any optical surfaces.
Supplies for cleaning optical surfaces
•
Soft camel-hair brush
•
Dust-free blower: Filtered dry nitrogen blown through an anti-static nozzle
•
Dust-free lens tissue, such as: Optowipes (18LAB022), Kim Wipes, or equivalent
•
For lens only: Lens cleaning solution
•
Cotton swabs with wooden stems only
•
Lens cleaning cloth/microfiber
Replacing the color sensor board harness
If the color sensor board harness becomes damaged during installation, replace it with the enhanced
harness included with the kit.
1. Remove the following system components:
a. Side intake cover
b. Radiator module
c.
Radiator fan intake module
d. Light engine fan intake module
e. HKBB cover (A)
Upgrading the Color Sensor Board Instruction Sheet
020-103100-01 Rev. 1 (06-2019)
Copyright
2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Upgrading the color sensor board
6
Advertisement
