Paper Door Assembly - Sony UP-DR200 Service Manual

7. Remove the four screws, then remove the ribbon door
assembly in the direction of the arrow.
8. Remove the four hooks, then remove the inner cover
(front).
BVTT3 x 6
BVTT3 x 6
Hooks
Inner cover
(front)
Hooks
9. Attach the ribbon door assembly in the reverse order
of steps 1 to 8.
n
When attaching the paper eject guide cover, attach it
so that the discharging brush is placed under the
ribbon roller (CH).
Paper eject guide cover
UP-DR200
BVTT3 x 6
Ribbon door
assembly
Ribbon roller (CH)
Discharging brush

1-6-2. Paper Door Assembly

1. Remove the top panel assembly.
(Refer to Section 1-4-1.)
2. Remove the side panel (R) assembly/side panel (L)
assembly. (Refer to Section 1-4-2.)
3. Remove the two snap rings (E3.0), then remove the
paper arm levers.
4. Remove the two snap rings (E5.0), then remove the
paper door shaft and two bearings (6).
5. Remove the paper door assembly.
Bearing (6)
E5.0
Paper door
shaft
Paper arm lever
E3.0
Paper door assembly
6. Attach the paper door assembly in the reverse order of
steps 1 to 5.
E3.0
E5.0
Bearing (6)
Paper arm lever
1-7