Sony UP-DR200 Service Manual page 63

. . . . . LOAD NEW PAPER & RIBBON
Detection sensor: Paper sensor or ribbon mark sensor
Contents: . The remaining ribbon of IC tag information became zero (0)
. The cue mark of ink ribbon cannot be detected.
. The paper sensor cannot detect the printing paper during paper transport.
Possible cause: 1. Printing paper or ink ribbon was used up.
2. The ribbon mark sensor is dirty.
3. The paper sensor or harness is defective. (SE-929 board)
(Refer to "4-6. Sensor Detection".)
4. The ribbon mark sensor or the related harness is defective. (LE-352 board, SE-934
board) (Refer to "4-6. Sensor Detection".)
5. Since the takeup motor or driving block is defective, a ribbon cannot be wound or
the winding speed is slow. (SU-137 board)
(Refer to "4-2. Motor Control".)
. . . . . UNSUPPORTED RIBBON
ERROR LOG display: TAG RW ERROR
Detection sensor: IC tag sensor
. An inadequate data is detected in the IC tag information.
Contents:
. The security check of the IC tag is NG.
Possible cause: 1. A ribbon for the different model is installed in this unit.
2. The IC tag is defective.
3. A ribbon is not installed correctly.
4. IC tag contact mechanical block is defective.
5. IC tag sensor or the related harness is defective. (CN-3048 board)
(Refer to "4-6. Sensor Detection".)
. . . . . UNRECOGNIZED RELOAD RIBBON
ERROR LOG display: TAG RW ERROR
Detection sensor: IC tag sensor
Contents: When updating the remaining amount of ribbon, the IC tag information cannot be
read or written correctly.
Possible cause: 1. The IC tag is defective.
2. A ribbon is not installed correctly.
3. IC tag contact mechanical block is defective.
4. IC tag sensor or the related harness is defective. (CN-3048 board)
(Refer to "4-6. Sensor Detection".)
ERROR LOG display: TAG DETECT ERROR
Detection sensor: IC tag sensor
Contents: When updating the remaining amount of ribbon, the IC tag cannot be detected.
Possible cause: 1. The IC tag is defective.
2. IC tag contact mechanical block is defective.
3. IC tag sensor or the related harness is defective. (CN-3048 board)
(Refer to "4-6. Sensor Detection".)
UP-DR200
6-3