Paper Eject Guide Assembly; Paper Holder Stay Assembly - Sony UP-DR200 Service Manual

1-6-9. Paper Eject Guide Assembly

1. Remove the cabinet (Refer to Section 1-4.)
2. Remove the ribbon door assembly.
(Refer to Section 1-6-1.)
3. Remove the cutter unit. (Refer to Section 1-6-5.)
4. Remove the supply drive assembly.
(Refer to Section 1-6-7.)
5. Disconnect the harness from the connector (CN462)
on the CN-3049 board.
6. Remove the four screws, then remove the paper eject
guide assembly.
7. Remove the two hooks, then remove the SE-933
board.
8. Disconnect the harness from the connector (CN401)
on the SE-933 board.
9. Remove the screw, then remove the LE-351 board.
10. Disconnect the harness from the connector (CN391)
on the LE-351 board.
Harness
Hooks
CN391
LE-351 board
BVTT
CN-3049 board
3 x 6
CN462
11. Attach the paper eject guide assembly in the reverse
order of steps 1 to 10.
1-12
Harness
CN401
SE-933 board
BVTT
3 x 6
Paper eject
guide assembly

1-6-10. Paper Holder Stay Assembly

1. Remove the cabinet. (Refer to Section 1-4.)
2. Remove the ribbon door assembly.
(Refer to Section 1-6-1.)
3. Remove the paper door assembly.
(Refer to Section 1-6-2.)
4. Remove the paper holder (main) assembly.
(Refer to Section 1-6-3.)
5. Remove the cutter unit. (Refer to Section 1-6-5.)
6. Remove the paper eject guide assembly.
(Refer to Section 1-6-9.)
7. Disconnect the harness from the connector (CN464)
on the CN-3049 board.
8. Remove the four screws (BVTT3 x 6), then remove
the paper holder stay assembly.
9. Remove the screw (BVTT2 x 10), then remove the
SE-931 board and door lock spring.
10. Disconnect the harness from the connector (CN351)
on the SE-931 board.
Harness
BVTT
2 x 10
BVTT
CN351
3 x 6
CN-3049 board
11. Attach the paper holder stay assembly in the reverse
order of steps 1 to 10.
SE-931 board
Door lock spring
Paper holder
stay assembly
BVTT
3 x 6
CN464
UP-DR200