Table of Contents
Advertisement
G
COPY button (29)
Press to print another copy of the previous printout.
You can make only one copy each time you press
this button regardless of the print quantity set using
the menu.
H
PRINT button (25, 30)
Press to print the image currently displayed on the
video monitor. The image displayed when you
press the PRINT button is stored in memory.
I
OPEN button (16, 29)
Press to open the door panel. While a print job is in
progress, press to cancel the print job.
J
Paper cutters
Use to cut the paper after printing.
There are cutters positioned above and below the
output slot.
Rear Panel
A t VIDEO input connector (BNC type)
Connect to the video output connector of the video
equipment.
B T VIDEO output connector (BNC type)
Connect to the video input connector of the video
monitor.
The image from the VIDEO input connector
outputs to the monitor.
C
REMOTE (remote commander) connector
(13)
Connects the RM-91 remote commander unit or the
FS-24 foot switch for controlling print operation
from a distance.
D
USB connector (type A) (30)
Connect a USB flash drive.
This connector also supplies power to optional
accessories.
Note
Do not connect to a USB device other than a Sony
flash memory formatted with FAT16 or FAT32 in
64GB or less.
E USB connector (type A) lamp
If an unsupported USB device is connected, this
lamp will flash in orange.
F
USB connector (type B)
Connects to a computer equipped with the USB
interface, using a USB cable compatible with Hi-
Speed USB (sold separately).
G - AC IN connector
Use a specified power cord.
Refer to “Warning on power connections” (page 8)
and “Warning on power connections for medical
use” (page 9).
H
Equipotential terminal
Used to connect to the equipotential plug to bring
the various parts of a system to the same potential.
Refer to “Important safeguards and notices for use
in the medical environments” (page 3).
Page 12
Hide quick links:
Advertisement
Table of Contents
