Thermo Scientific invitrogen EVOS M5000 Manual page 103

Optional
: Set
Temperature Offset
EVOS M5000 Imaging System User Guide
™
Note: Alternatively, go to the Settings tab, click Incubator to display the Incubator
panel, then click Main Incubator Control to open the Incubator Control window.
5. Select Enable to turn on the incubator.
6. Select the desired Shutdown option:
•
Manually shutdown: The incubator will remain on until the Enable
option is manually deselected and the Close button is clicked.
•
Automatic shutdown: Select Shutdown after, then enter the time in
Hours and Minutes that must elapse before the incubator is shut down
automatically.
7. Enter the target values for Temperature, CO
Humidity to use a humidified atmosphere in the incubator chamber.
Incubator status will change to "Running" and the control panel will display
the Target and Actual values for Temperature, Humidity, CO
8. Click Close to return to the Capture tab.
Note: Place an empty culture plate into the vessel holder/adaptor for the initial
warm up and equilibration to prevent build-up of condensation on the optical
components and the inside of the EVOS
Ambient Offset allows you to adjust temperature readings based on the ambient
room temperature. This should remain at 0 by default.
1. Go to the Settings tab, then click Incubator to display the Incubator panel.
2. Click Incubator Setup to open the Incubator Setup window.
3. Enter the appropriate temperature for the Ambient Offset in the Incubator
Setup window, then click Apply.
, and Oxygen. If desired, select
2
™ M5000 Imaging System.
, and Oxygen.
2
101