Replacing The Keypad; Replacing The Speaker/Buzzer - Husqvarna Automower Solar Hybrid Technical Manual

5.10 Replacing the keypad

1. Dismantle the body.
2. Unscrew the four screws, torx 20, holding the
display cover.
3. Remove the cable to the keypad from the display
circuit card.
4. Unscrew the rubber cap on the main switch and
pass the main switch out through the hole.
5. Pull off the keypad and pass the cable out
through the hole.
6. Remove the protective film, press on a new
keypad and connect the cable to the
display-circuit card.
Make sure you press the keypad carefully and
firmly into position. There must be no loose
corners or air bubbles, as dirt and moisture can
enter under the keypad.
Ensure that the cable to the display circuit card is
connected the right way. If the cable is
connected incorrectly, the buttons will not
correspond with the menu functions.
7. Refit the main switch and screw on the rubber
cap.
8. Check that the keypad works.
9. Assemble the body.

5.11 Replacing the Speaker/buzzer

1. Dismantle the body and chassis.
2. Press down the catch on the connector to the
speaker/buzzer and disconnect the cable.
3. Unscrew the two screws holding the
speaker/buzzer.
4. Lift out the old speaker/buzzer and replace with a
new one.
5. Refit the screws and connect the cable.
6. Test that the speaker/buzzer works.
7. Fit the chassis and body.
The internal buzzer (210 C, 230 ACX and Solar
Hybrid) is fitted on the control box. The whole
control box must be replaced if this is defective.
5. REPAIR INSTRUCTIONS
3012-453
3012-446
English - 93