Replacing The Main Switch; Replacing The Micro Switch, Stop Button (210 C, 220 Ac And 230 Acx); Replacing The Micro Switch, Stop Button (Solar Hybrid) - Husqvarna Automower Solar Hybrid Technical Manual

5.12 Replacing the main switch

1. Dismantle the body.
2. Unscrew the four screws, torx 20, holding the
display cover.
3. Unscrew the rubber cap on the main switch.
4. Turn the display cover and remove the main
switch connection from the display circuit card.
5. Pull the main switch out of the hole.
6. Insert the new main switch in the hole and connect
its cable to the display circuit card.
7. Screw the rubber cap onto the main switch.
8. Screw on the display cover.
9. Check that the main switch works
10. Assemble the body.
5.13 Replacing the micro switch,
stop button (210 C, 220 AC and
230 ACX)
1. Dismantle the body.
2. Remove the microswitch on the stop button.
3. Unscrew the four screws, torx 20, holding the
display cover.
4. Remove the micro switch connection from the
display circuit card.
5. Connect the new micro switch to the display circuit
card.
6. Make sure the switch's rubber seal is fitted
correctly on the display cover.
7. Screw on the display cover.
8. Check that the microswitch and stop button work.
9. Assemble the body.
5.14 Replacing the micro switch,
stop button (Solar Hybrid)
1. Remove the solar panel, follow the instructions for
replacing the solar panel, see page99.
2. When the panel has been removed, place it
upside down on a soft surface.
NOTE! The solar cells are extremely sensitive to
pressure and knocks.
3. Unscrew the eight screws holding the inner cover.
4. Cut off the wires that run to the cover switch, cut
the wires approximately 16 cm (6") from the
switch.
94 - English
5. REPAIR INSTRUCTIONS