Husqvarna Automower Solar Hybrid Technical Manual page 78

4. AUTOCHECK, SERVICE PROGRAM
4.8.5 Settings
This function can be used to collect all information
concerning the settings in the Automower connected to
the computer. You can also change these settings and
then transmit the changes to the mower.
When you select the Settings function the present
settings are automatically displayed.
Press the tab for Program A, B or C to show the
settings that are saved under the relevant program.
To save changed settings: Pres the Save button at the
top right. Note that the settings are only saved for the
program that is displayed at that time. It is also
possible to copy settings from one program to another.
To copy settings: Select the program from where the
settings are to be copied by clicking on the tab for the
relevant program. Then select the program to which the
settings are to be copied in the menu bar Copy to.....
Settings: Miscellaneous
On the Settings, Miscellaneous menu there are a
number of special functions, these are described
below.
Settings: Loop detection
On some occasions you may need to turn off a
mower's loop detection for a little while. This may be
when an Automower needs to be demonstrated when
a charging station and boundary wire have not been
installed, i.e. at a customer's home.
NOTE!
Remember to reactive loop detection again.
To deactivate loop detection:
1. Deselect the Loop detection checkbox.
2. Click on Save.
To activate loop detection again:
1. Select the Loop detection checkbox.
2. Click on Save.
Settings: Demo mode
In order to make it easier to demonstrate an
Automower it is equipped with a demo mode. You can
use different settings in the different programs for
Demo mode.
To activate demo mode:
1. Select the Demo mode checkbox.
2. Click on Save.
When the function is activated the Automower works
without starting the blade disc. The mower varies
running with charging at four minute intervals.
78 - English
3012-600