Upgrading The Firmware - dji MATRICE 600 PRO User Manual

MATRICE 600 PRO User Manual

Upgrading the Firmware

Upgrading the Aircraft and Lightbridge 2 Air System Firmware
Connect the aircraft to the DJI Assistant 2 to upgrade the aircraft's and Lightbridge 2 Air System's
firmware. Refer to DJI Assistant 2 (p. 30) for details.
Upgrading the Remote Controller Firmware
The System Status bar in Camera View of the DJI GO app will flash several times if a firmware
upgrade is available. Follow these steps to upgrade the firmware via the DJI GO app.
1. Go to the DJI GO app > Camera View > System Status bar > Overall Status. Tap Download
Firmware to download and upgrade the firmware.
2. A progress bar in the DJI GO app will indicate the upgrade status. The Status LED on the remote
controller will be solid blue while the upgrade is in progress and it will turn solid green when the
upgrade is successful. The LED will turn solid red if the upgrade fails. Restart the remote controller
and try again.
DO NOT perform the firmware upgrade while the aircraft is flying in the air. Only carry out
the firmware upgrade when the aircraft is on the ground.
Both the Lightbridge 2 Air System and the remote controller firmware must be up-to-date, or
else they will not link.
Check in the DJI GO app that you have the latest firmware installed before each flight.
The firmware upgrade requires an internet connection. Connect your mobile device to a Wi-Fi
network whenever possible.
DO NOT power off the remote controller during the upgrade.
The remote controller may become unlinked from the aircraft after the firmware upgrade.
Relink the remote controller and aircraft if necessary.
Upgrading the Zenmuse Z30, Z3, X3, X5 Series, XT and XT 2 Firmware
If you are using a Zenmuse Z30, Z3, X3, X5 series, XT or XT 2 gimbal and camera, mount the gimbal
and camera to the aircraft and follow the steps below to upgrade its firmware via a Micro SD card.
Be sure to unplug the gimbal attitude cable before camera firmware update, or else
firmware update will fail. Ensure that the aircraft is powered off before unplugging the cable.
Ensure that there is only one version of update file in the Micro SD card, or else there will be
an update error.
Step 1- Check the Battery Level and Micro SD Card Storage
a. Ensure that the Intelligent Flight Batteries have at least 50% power level. Power on one of the
batteries and ensure that other batteries are triggered automatically. If not, find solutions in the DJI
GO app.
b. Ensure that there is at least 100MB of free space on the Micro SD card.
Step 2- Prepare the Firmware Update Package
a. Download the firmware update package from the Matrice 600 Pro page on the DJI website.
(http://www.dji.com/matrice600-pro/info#downloads)
48
©
2017 DJI All Rights Reserved.