Seametrics INW Manual page 12

Temperature
You cannot change display units for temperature. They will always display in degrees
Celsius. However, if you are using other than PSI for pressure and you later want to
read temperature, you must set the display units per the chart below. Failure to do this
will result in erroneous temperature readings. If you switch back to pressure, you must
reset for pressure units again.
Units
Temperature -10.000
Default - if only using PSI
If you have been using other than PSI for pressure units and wish to return to using
just PSI, then change the display units as shown in this chart.
Units
Default
Once these defaults have been reset, you can switch between reading pressure and
reading temperature without having to change the display settings.
Seametrics • 253.872.0284
Input 1
Input 1
-199.999
PANEL METER FOR INW PT12 SENSOR
Display 1
-10.000
Display 1
-199.999
Page 12
Input 2 Display 2
100.000
Input 2 Display 2
999.999
100.000
999.999
inwusa.com