Troubleshooting
If there is a jam in the appliance
This means that you may have fed too much paper into the appliance (max.
7 sheets 80 g/m2 for manual feeding, max. 75 sheets 80 g/m 2 for automatic
feeding).
During automatic feeding, the appliance will beep until the paper jam is cleared.
During manual feeding
red until the paper jam has been cleared.
♦
Slide the AUTO/OFF/REV switch
material being shredded gets stuck. The appliance now goes into reverse
and the material is ejected.
The power/bin full LED
♦
Pull the material being cut out of the appliance and then slide the AUTO/
OFF/REV switch
The appliance is now ready for use.
If the appliance suddenly stops working
This means that the appliance has overheated and the automatic safety cut-out
has activated. The overheat/overload LED
♦
Slide the AUTO/OFF/REV switch
full LED
♦
Remove the plug from the mains power socket.
♦
Allow the appliance to cool down for about 30 minutes.
♦
Replace the plug in the mains power socket.
♦
Switch the appliance on by sliding the AUTO/OFF/REV switch
AUTO position. The power/bin full LED
overheat/overload LED
down sufficiently.
The appliance is now ready for use.
If the appliance cannot be switched on
♦
Check whether the mains plug is plugged into the mains socket.
♦
Check whether the overheat/overload LED
on, the overheating protection has been triggered. Proceed as described in
the section "Overheating protection".
♦
Try a different wall socket.
♦
Make sure the cutter attachment
tor
♦
The appliance is possibly defective. Have the appliance checked by a
qualified technician.
UAVK 180 A1
, the overheat/overload LED
to AUTO.
and the overheat/overload LED
.
to the REV (reverse) position if the
continuously lights up blue.
lights up continuously red.
to the OFF position. The power/bin
go out.
continuously lights up blue. The
remains off when the appliance has cooled
has come on. If it has come
is seated correctly on the waste collec-
flashes continuously
to the
GB │ IE
│
23
■