Panasonic CS-Z20XKEW Service Manual page 49

Terminals on the outdoor unit
Colour of wires (connection cable)
Terminals on the indoor unit
(Power supply cord)
Terminals on the isolating devices
(Disconnecting means)
8 Secure firmly the power supply cord and connecting cable onto the control board with the holder.
Do not overtighten holder screw, as this may damage the holder.
9 Close grille door by tighten with screw and close the front panel.
Note:

Isolating Devices (Disconnecting means) should have minimum 3.0 mm contact gap.

Ensure the colour of wires of outdoor unit and the terminal Nos. are the same to the indoor's respectively.

Earth wire shall be Yellow/Green (Y/G) in colour and longer than other AC wires as shown in the figure for the
electrical safety in case of the slipping out of the cord from the anchorage.
Power
supply
cord
S1 2 3
L 1 N S1 2 3
(L) (N)
a
b
Recommended
length (mm)
30 30
Terminal Board
S1
Panel
1
a b
c
Earth Wire
longer than
others AC wires
for safety reason
Left escapement
Holder 4
Power supply
cord
Flip the panel down
until 'click' sound before
Isolating Devices
connect indoor and
outdoor connection cable
Tape
Connection cable
1 2 3
OR L 1 N S1 2 3
*
Connection for multi inverter
model (Outdoor power
supply)
g
c e
d f
60 45 40 35 55
S1
Flip the
panel down
Panel
Right escapement
connection cable
49
Tape
Recommended
length (mm)
refer table below
g
d e
f
Earth Wire
longer than
1
others
AC wires
for safety
reason
Holder
6
Indoor & outdoor
Outdoor Unit
WARNING
This equipment
must be properly
earthed.