Panasonic CS-Z20XKEW Service Manual page 18

Model
Dimension Unit
Weight Net (I/D / O/D)
Pipe Diameter (Liquid / Gas)
Standard Length
Length Range (min - max)
I/D & O/D Height Different
Additional Gas Amount
Length for Additional Gas
Inner Diameter
Drain Hose
Fin Material
Indoor Heat
Exchanger
Row x Stage x FPI
Size (W x H x L)
Fin Material
Outdoor Heat
Exchanger
Row x Stage x FPI
Size (W x H x L)
Air Filter
Power Supply
Power Supply Cord
Thermostat
Protection Device
Indoor Operation Range
Outdoor Operation Range
1. Cooling capacities are based on indoor temperature of 27°C Dry Bulb (80.6°F Dry Bulb), 19.0°C Wet Bulb (66.2°F Wet Bulb) and outdoor air
temperature of 35°C DRY BULB (95°F Dry Bulb), 24°C Wet Bulb (75.2°F Wet Bulb).
2. Heating capacities are based on indoor temperature of 20°C Dry Bulb (68°F Dry Bulb) and outdoor air temperature of 7°C Dry Bulb (44.6°F
Dry Bulb), 6°C Wet Bulb (42.8°F Wet Bulb).
3. Network Impedance shall be applicable for Europe models only.
4. The annual consumption is calculated by multiplying the input power by an average of 500 hours per year in cooling mode.
5. EER and COP Class: Refer Att 11, RAD-A-04-06, eg. Europe: classification is at 230V only in accordance with EU directive 2003/31/EC,
A – G, Australia: n star, Singapore: Tick n, etc.
6. Heating low temperature capacity, Input Power and COP measured at 230 V, indoor temperature 20°C, outdoor 2/1°C.
7. Heating extreme low temperature capacity, Input Power and COP measured at 230 V, indoor temperature 20°C, outdoor -7/-8°C.
8. Standby power consumption ≤2.0W (when switched OFF by remote control, except under self protection control).
9. Specifications are subjected to change without prior notice for further improvement.
10. SEER and SCOP classification is at 230V only in accordance with EN-14825. For heating, SCOP indicates the value of only Average heating
season. Other fiche data indicates in an attached sheet.
Outdoor
Height (ID / OD) mm (inch)
Width (ID / OD) mm (inch)
Depth (ID / OD) mm (inch)
mm (inch)
g/m (oz/ft)
Length
Fin Type
Fin Type
Material
Type
Maximum °C (°F)
Cooling
Minimum °C (°F)
Maximum °C (°F)
Heating
Minimum °C (°F)
Maximum °C (°F)
Cooling
Minimum °C (°F)
Maximum °C (°F)
Heating
Minimum °C (°F)
Indoor
kg (lb)
m (ft)
m (ft)
m (ft)
m (ft)
mm
mm
mm
mm
18
CS-Z25XKEW, CS-XZ25XKEW
CU-Z25XKE
295 (11-5/8) / 542 (21-11/32)
870 (34-9/32) / 780 (30-23/32)
229 (9-1/32) / 289 (11-13/32)
10 (22) / 27 (60)
6.35 (1/4) / 9.52 (3/8)
5.0 (16.4)
3 (9.8) ~ 15 (49.2)
15.0 (49.2)
10 (0.1)
7.5 (24.6)
16.7
650
Aluminium (Pre coat)
Slit Fin
2 x 17 x 21
644.5 x 357 x 25.4
Aluminium (Pre coat)
Corrugated Fin
2 x 24 x 19
36.4 x 504 x 824.2:793.7
Polypropelene
One-touch
Indoor
NIL
Electronic Control
Electronic Control
Dry Bulb
32
16
30
16
43
-10
24
-15
Wet Bulb
23
11
-
-
26
-
18
-16