Main Frame; Sdi-99 Board; Hif-62 Board - Sony HDCU2500 Maintenance Manual

4-6.

Main Frame

4-6-1.

HIF-62 Board

Preparation
1. Remove the rear panel assembly. (Refer to
Procedure
1. Disconnect the harness from the connector CN12 on the CN-2675G board.
2. Remove the two screws, and remove the rear sub assembly (included in the HIF-62 board and the SDI-99 board).
3. Disconnect the flexible flat cable from the connector CN11 on the CN-2675G board.
4. Remove the three screws to detach the shield finger (BNC) and the HIF-62 board.
HIF-62 board
5. Install the removed parts by reversing the steps of removal.
4-6-2.

SDI-99 Board

Preparation
1. Remove the rear panel assembly. (Refer to
HDCU2500
"4-4-1. Removal and Installation of Rear Panel
CN-2675 board
Harness
CN11
Flexible flat cable
B3 x 5
Shield finger
B3 x 5
"4-4-1. Removal and Installation of Rear Panel
Assembly")
CN12
Rear sub
assembly
Assembly")
4-21