4-3.
Front Panel
4-3-1.
Removal and Installation of Front Panel
1.
Loosen the two coin screws, and open the front panel.
2.
Disconnect the flexible flat cable from the connector CN1 on the AU-340 board.
AU-340 board
Coin screws
Front panel
3.
Remove the step shaft, and remove the front panel from the shaft of the incom panel.
Front panel
4.
Install the removed parts by reversing the steps of removal.
4-3-2.
CN-3451 Board
Preparation
1.
Open the front panel. (Refer to
Procedure
1.
Disconnect the harness from the connector CN2 on the CN-3451 board.
HDCU2500
Flexible flat cable
CN1
Shaft
(Incom panel)
Step shaft
"4-3-1. Removal and Installation of Front
Panel")
4-13