Sony HDCU2500 Maintenance Manual page 96

C06: MIC/AUDIO
Menu Image
<MIC/AUDIO> C06 TOP
CAM MIC GAIN: (LOCAL)
CH1 : ---
CH2 : ---
AUDIO OUT
DELAY : 0FS
ANALOG OUT : MIC1/2
AES/EBU OUT: MIC1/2
CH1 LEVEL : 0dbu
CH2 LEVEL : 0dbu
C07: INTERCOM
Menu Image
<INTERCOM> C07 TOP
INTERCOM CH : 2CH
SYSTEM INTERFACE
PRODUCER : 4WIRE
TERMINATION: (OFF)
CANCEL LVL : (
ENGINEER : 4WIRE
TERMINATION: (OFF)
CANCEL LVL : (
PGM1 INPUT : 0dbu
PGM2 INPUT : 0dbu
HDCU2500
Item
CAM MIC GAIN
CH1
CH2
AUDIO OUT
Item
INTERCOM
CH
SYSTEM IN-
TERFACE
PRODUCER
0)
TERMINA-
0)
TION
CANCEL
LVL
ENGINEER
TERMINA-
TION
CANCEL
LVL
PGM1 IN-
PUT
PGM2 IN-
PUT
Settings Description
— Sets the camera's microphone gain.
---, 20, Settings vary depending on micro-
30, 40, phones.
50, 60 dB --: Displayed when a camera is not
connected. (Display only)
DELAY 0 to Sets the camera's microphone output
3840FS phase.
ANALOG MIC 1/2, Selects the MIC OUT ANALOG out-
OUT AES, put.
EBU
AES/EBU MIC 1/2, Selects the MIC OUT DIGITAL out-
OUT AES, put.
EBU
CH1 LEV- 0, +4, Sets the AUDIO CH1 output level.
EL –20dBu
CH2 LEV- 0, +4, Sets the AUDIO CH2 output level.
EL –20dBu
Settings Description
1CH, 2CH Selects the intercom channel number.
4WIRE, RTS, Sets the D-sub 25-pin intercom system.
CLEAR COM
4WIRE, RTS, Sets the producer line intercom system.
CLEAR COM
(OFF), ON, OFF Connects to a 200 Ω terminator, if ON is
selected while 2-wire intercom interface is
used.
(OFF): Displayed when 4WIRE is selected
in SYSTEM I/F. (Display only) (Display
only)
— Sets the side tone cancel level.
4WIRE, RTS, Sets the engineer line intercom system.
CLEAR COM
(OFF), ON, OFF Connects to a 200 Ω terminator, if ON is
selected while 2-wire intercom interface is
used.
(OFF): Displayed when 4WIRE is selected
in SYSTEM I/F. (Display only) (Display
only)
— Sets the side tone cancel level.
–20, 0, +4 dBu Sets the PGM1 input level.
–20, 0, +4 dBu Sets the PGM2 input level.
3-20