Function And Location Of Parts And Controls; Front Panel - Sony CCU-590 Operation Manual

Camera contol unit
Hide thumbs Also See for CCU-590:
Table of Contents

Advertisement

Function and Location of Parts and Controls

Front panel

aCamera number sheet/tally indicator
a Camera number sheet/tally indicator
Lights red when the red tally signal is input (e.g. when the
video signal from the video camera connected to the CCU-
590/590P goes on air). When the CALL button on the
video camera, MSU-900/950, RCP-750/751 series remote
control panel, or an optional RM-B750 is pressed, the
indicator lights if it is not lit, and goes off if it is lit.
The indicator lights green when the green tally signal is
input (e.g. when the video signal from the camera
connected to the CCU-590/590P goes off air).
Attach the supplied number sheet here to indicate the
camera number.
b POWER switch/CAM (camera) and MAIN
indicators
The POWER switch turns on or off the power supply to the
entire camera system, including the CCU-590/590P, the
video camera, and the remote control unit connected to the
REMOTE connector on the CCU-590/590P.
The MAIN and CAM indicators light when the POWER
switch is turned on.
The CAM indicator goes off when the power is turned off
by the CAM PW button on the remote control panel or the
6
Function and Location of Parts and Controls
b POWER switch/CAM and MAIN indicators
CAM
OPEN
MAIN
"
SHORT
1
MIC –
ON
PROD
OFF
PRIV
PGM
PGM
d INCOM input/output/setting section
c CABLE ALARM indicators
master setup unit, or CAM POWER switch on the internal
AT board.
Note
If the fan in the CCU-590/590P stops, the MAIN indicator
will flash to warn you of the abnormal condition. If this
occurs, turn the POWER switch off immediately and
contact Sony service personnel.
c CABLE ALARM indicators
OPEN: Lights when no triax cable is connected to the
CAMERA connector on the rear panel of the CCU-
590/590P, or when the load current is extremely low
even when a camera cable is connected.
SHORT: Lights when there is a current overflow in the
triax cable.
d INCOM audio input/output/setting section
INCOM (intercom) connector (XLR, 5-pin)
Connects a headset.
INCOM level control
Adjusts the input level of the intercom.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ccu-590p

Table of Contents