Pbd-1200A Dual Blower Horizontal Ducting - Zephyr Tempest II AK7500CS Use, Care And Installation Manual

Installation Instructions

PBD-1200A Dual Blower Horizontal Ducting

Follow Steps 1 through 4 on page 22-23, then continue PBD-1200A horizontal ducting installation by
following the steps below.
24
5. Knock out plate A for dual blower
A
horizontal ducting.
6. Position dual blower inside hood
body. Attach by (4) screws
previously removed from step 2.
7. From inside hood body, position
top cover plate to top of hood
body. From outside hood body,
attach top cover plate to top of
hood body using (4) 3/16 x 3/8
screws.
8. Attach 10 inch round blower
collar to back of hood using (4)
M3.5 x 8 screws. Connect blower
wire extension cable to new
blower and connect both plugs
from each blower to female plugs
behind switch panel.
Tempest II Use, Care, and Installation Guide
P R O
T E M P E S T I I
U N D E R - C A B I N E T