Advertisement
Fig. 1
Roughing-in Dimensions
Right or Left Hand Installation
(Section 5)
See
for converting Flush
Valve to Left Hand Installation.
73mm
(2-7/8")
120mm
(4-3/4")
MANUAL
OVERRIDE
BUTTON
-C-L-
292mm
(11-1/2")
*-C-L-
152mm MIN.
(6") MIN.
*Note: The Critical Line (-C-L-) on Vacuum
Breaker must typically be 6
fixture. Consult Codes for details.
RECOMMENDED TOOLS; Fig. 2
1.
Teflon Tape
2.
Flat Blade Screwdriver
3.
Adjustable Wrench
4.
Tape Measure
5.
Hacksaw
6.
Tubing Cutter
7.
File
8.
For Sweat Connection; Solder and Torch
9.
2.5mm Hex Wrench
10.
1.5mm Hex Wrench
PRIOR TO INSTALLATION
Note: Prior to installing the Selectronic™Flush Valve
the following items must be installed.
1. Toilet
2. Drain line
3. Water supply line
IMPORTANT:
• All plumbing and electrical wiring must be installed in
accordance with applicable codes, regulations and
standards.
• The use of water hammer arrestors is strongly
recommended for commercial applications. All piping
behind the walls should be properly secured and
fastened.
• Water supply lines must be sized to provide an
adequate volume of water for each fixture.
CAUTION: Use only American Standard
supplied cable sets. Using non-AS supplied
cables, or cutting, splicing or modifying any
components will void the warranty.
SEE DETAIL "A"
51mm (2") HOLE
FOR CONDUIT
305mm MAX.
(12" MAX.)
86mm
(3-3/8)
(1" NPT)
412mm
(16-3/16")
108mm - 134mm
(4-1/4") - (5-1/4")
TOP OF
FIXTURE
"
(152mm) above
FINISHED WALL
DETECTION ZONE: 400mm-800mm
(FACTORY SETTING: 400mm)
15˚
FINISHED WALL
OPENING
SCREW HOLES
170mm MAX.
(6-11/16") MAX.
Fig. 2
1
5
7
• Flush all water lines prior to operation (See Step 4). Dirt
and debris can cause flush valve to run continuously.
With the exception of Stop Valve Inlet, DO NOT
•
use pipe sealant or plumbing grease on any
valve component or coupling!
• Protect the chrome or special finish on the Flushometer.
DO NOT USE toothed tools on finished surfaces to install
or service these valves. Also see "Care and Cleaning"
section of this manual.
• This product contains mechanical and/or electrical
components that are subject to normal wear. These
components should be checked on a regular basis and
replaced as needed to maintain the valve's performance.
2
GENERAL DESCRIPTION:
SELECTRONIC™
PROXIMITY TOILET
FLUSH VALVE
Exposed Flushometer
for 1-1/2" Top Spud Fixtures
Exclusive, self cleaning piston-type flush
valve with proximity operation and
manual override. Operates on AC power.
Recommended operating pressure 20psi
(flowing) to 80 psi (static). Can install left
or right-handed. Detection Zone can also
be adjusted manually, or with optional
remote control.
4" (102 mm) SQ. BOX DEVICE COVER (PLASTER RING).
3/4" (19 MM) HIGH Hubbel-RACO #779 OR EQUAL
(BY CONTRACTOR).
NOTE: INSTALL PLASTER RING SO THAT SCREW
HOLES ARE ON THE LEFT AND RIGHT SIDE OF BOX.
FINISHED TILE WALL
DETAIL "A"
FINISHED PLASTER WALL
4" (102mm) SQ. X 3-1/2" (89mm) DEEP ELECTRICAL BOX
Hubbel-RACO #256 OR EQUAL (BY CONTRACTOR).
2
3
4
10'
6
9
10
M965644 REV. 1.1 (12/14)
8
Advertisement
