General Description; Prior To Installation - American Standard Ultima Selectronic 6066.111 Installation Instructions Manual

Fig. 1
Roughing-in Dimensions
Right or Left Hand Installation
See (Section 5) for converting Flush Valve to Left Hand Installation.
MANUAL
OVERRIDE
BUTTON
292 mm
(11-1/2")
*Note: The Critical Line (-C-L-) on Vacuum
Breaker must typically be 6
fixture. Consult Codes for details.
RECOMMENDED TOOLS; Fig. 2.
1. Teflon Tape
2. Flat Blade Screwdriver
3. Adjustable Wrench
4. Tape Measure
5. Hacksaw
6. Tubing Cutter
7. File
8. For Sweat Connection; Solder and Torch
9. 2.5 mm Hex Wrench
10. 1.5 mm Hex Wrench

PRIOR TO INSTALLATION

Note: Prior to installing the Selectronic™Flush
Valve the following items must be installed.
1. Toilet
2. Drain line
3. Water supply line
IMPORTANT:
• All plumbing and electrical wiring should be
installed in accordance with applicable codes
and regulations.
• The use of water hammer arrestors is strongly
recommended for commercial applications. All piping
behind the walls should be properly secured and
fastened.
• Water supply lines must be sized to provide an
adequate volume of water for each fixture.
73 mm
(2-7/8")
127 mm
(5")
-C-L-
108mm-134mm
(4-1/4" TO 5-1/4")
*-C-L-
152mm MIN.
(6") MIN.
FOR 1-1/2" TOP
SPUD FIXTURES
"
(152mm) above

GENERAL DESCRIPTION:

SELECTRONIC® PROXIMITY TOILET FLUSH VALVE
Exposed Flushometer for 1-1/2" Top Spud Fixtures
FINISHED WALL
SUPPLY
(1" NPT.)
(NPT de 1")
419 mm
(16-1/2")
170 mm MÁX.
(6-11/16") MÁX.
Fig. 2
2
1
4
5
7
• Flush all water lines prior to operation. Dirt and debris
can cause flush valve to run continuously.
• With the exception of Stop Valve Inlet, DO NOT
use pipe sealant or plumbing grease on any
valve component or coupling!
• Protect the chrome or special finish on the Flushometer.
DO NOT USE toothed tools on finished surfaces to install
or service these valves. Also see "Care and Cleaning"
section of this manual.
• This product contains mechanical and/or electrical
components that are subject to normal wear. These
components should be checked on a regular basis and
replaced as needed to maintain the valve's performance.
3
15˚
DETECTION ZONE
400mm-800mm
(15-3/4 TO 31-1/2)
3
10'
6
8
9 10
M965841 Rev. 1.2 (1/19)