Wan Settings - Yeastar Technology TA1610 User Manual

WAN Settings

WAN port is disabled by default. If you want to use dual network, you should enable
WAN port, and configure the network settings and static routes to route network traffic
through the proper Ethernet interface.
Note: TA gateway does not act as a router to route the network traffic from WAN port
to LAN port.
Go to System→Network Preferences→WAN Settings to configure the WAN port of
TA1610.
Items
Use WAN
Mode
IP Address
Subnet Mask
Figure 9-4 WAN Settings
Table 9-2 WAN Settings
Whether to enable WAN port or not.
Note: If WAN port is enabled, the default network interface
is WAN.
Choose the network mode:

Static IP Address

DHCP

PPPoE
Set the IP Address of the public network.
Set the subnet mask of the public network.
TA1610 User Manual
Description
48/82