Turn-Point Navigation Page - RC Electronics FENIX User Manual

FENIX – user's manual Document Revision: 0.1
December 2020

3.3 Turn-point navigation page

Navigation towards turn-point can be set and viewed on Turn-point navigation page. Once
*.cup files are saved in to internal memory and selected under Setup / Transfer / Turn-points
will display turn-points on the map as drop like icons.
Figure 39: Turn-point navigation page reference.
With four navboxes indicators on side screens, the Turn-point navigation page offers additional
four navboxes on bottom side of map, which can be set in to the any type of indicators.
Above battery indicator, the name of the navigation page is displayed (Tp or turn-point).
Steering correction and the name of turn-point can be seen at top center of the map.
Since the steering course is calculated from your track and bearing to the target, the wind
component is already calculated into this value. When relative bearing is displayed with zero
degrees and blue line is aligned with red line, you are in fact moving in the direction of the
desired turn-point.
In addition, the wind direction can be always seen in left side of Wind and connectivity status
graphics box. For more info, you can go to subparagraph 3.1.4 of this document.
With short press on the bottom rotary knob, Select turn-point sub-page will be displayed with
the full list of all saved turn-points. For the desired turn-point, search can be done manually or
with the use of quick search function which can be selected in first line of list. In the quick
search the turn-points can be quickly sorted by entering Code, Name or Distance.
34