Drawbar; Scrapping - DAL-BO PowerRoll 1030 Manual



Drawbar:



Scrapping:

Remove the ram. The hoses can remain attached.
Remove the locking screws (pos. 2).
Hook onto the centre of the roller frame and lift so that the large pin can be
removed.
Take care. The frame can swing round.
Assemble in reverse order.
The drawbar should be replaced at a workshop which has a crane. Max.
weight 700 kg.
Put the roller on a level surface in working position without a tractor. Lift the
front end and remove the jack.
Lift just in front of the roller's main frame until the main pin is loose.
Remove the rams. This can be done without disconnecting the oil hoses.
Knock/pull the main pin´s out. Take care that the drawbar does not turn
round.
Assemble in reverse order.
Dismantle the roller in the following order:
1. Side shafts with rings, see page 11.
2. Central shaft with rings, see page 13.
3. Side sections, see page 18.
4. Wheels, see page 10.
5. Drawbar, see page 19.
Send the oil hoses, oil, tyres and hoses for incineration. The rest can be
melted down and reused.
21