Outer Sections; Intermediate Sections - DAL-BO PowerRoll 1030 Manual

Outer sections:

Outer sections should be replaced at a workshop. See fig. 14.
This job is best done with the roller in transport position.
Remove the shaft with roller rings as described above.
Hook onto roughly the middle of the frame and lift until the pin (pos. 1) can
be taken out.

Take care. As the pin is taken out, the roller frame can swing round.
Assemble in reverse order.
Fig. 14:

Intermediate sections:

Intermediate sections should be replaced at a workshop. See fig. 14.
This job is best done with the roller in transport position.
First remove the outer section as described above.
Secure the opposite section with a piece of rope to prevent it from swinging
out.
It must be able to tip up from the transport bearing.
Lift the roller sections free from the transport bearing using the large rams
(red hoses).
Swing the section in question out using the inner swing ram (blue hoses).
20