DAL-BO PowerRoll 1030 Manual page 14

14
Crosskill rings. Note the direction of rotation of the shaft. After the outside
stopring, fig. 8 pos.1, start with a small ring. It must face as shown in fig. 8.
Then fit a bushing.
On top of this fit a large ring which faces as shown in fig. 8.
Finish with a small ring. Make sure that the rings are tight up against each
other.
Fig. 8:
Roller centre
Welled rings. Start with two rings which are bolted together as shown in fig.
9.
Fill the shaft until approx. 22 cm is left. Then finish with two rings bolted
together. Make sure that the rings are tight up against each other.
Fig. 9:
Roller centre
Insert the stopring, fig. 8-10 pos. 2, and tighten well. It is advisable to undo
and tighten it several times so that the screws can grip properly. Then push
the bearings onto the shaft.