Handling; Assembly - DAL-BO PowerRoll 1030 Manual

Handling:

QTY PARTS
1 Drawbar
1 Central section without rings
2 Inner side section
2 Connecting link
2 Outer side section
2 Ram 110/50x700
2 Ram 80/40x350
2 Ram 63/30x400
2 Brake hub
2 Wheel 15.0/55-17
2 Wheel 19.0/45-17 (optional extra)

Assembly:




The 12.3 m PowerRoll generally comes disassembled for transport. It should
be assembled by you DAL-BO dealer's qualified fitters at a professional
workshop which has an approved crane/lifting tackle.
It consists of the following main parts:
See fig. 1.
The machine should be assembled by your Dal-Bo dealer's qualified fitters at
an "approved" workshop:
A crane which can lift at least 1000 kg should be used.
1. Fit the central section pos. 1 with roller rings, and position it in the centre
of a flat area of floor so that it is resting on the roller rings and wheel
hubs. There must be approx. 7 m of space on either side of the centre.
2. Fit the drawbar pos. 2 with the two pins pos. 3. They must be inserted
from the outside so that the square end plate prevents rotation.
Remember the split pin.
3. Connect the two red hoses to a double-acting valve on a tractor or pump
station and run the two large rams pos. 4 out to their maximum length.
4. Mount the two large rams on the drawbar and central section. So that the
central section stands vertically.
Remember washers and split pins.
5. Mount the rams pos. 5 on the central section.
Remember the split pins.
6. Secure the hydraulic hoses in the clamps.
6
WEIGHT CROSSKILL
approx.
435 -
625 720
330 720
60 -
100 615
41
21
20
70
62
68
CAMBRIDGE
-
875
875
-
745