Table of Contents
Advertisement
Using the roller with a non-original hydraulic circuit will invalidate the warranty.
Dal-Bo cannot be held liable for damage caused by a non-original hydraulic circuit.
Figure 2:
10. Mount the connecting links on the inner sections with the pin pos. 12.
Secure with the washer and screw the bolt, to which Loctite 270 has been
applied, firmly into the end of the pin.
11. Secure the rams for the outer sections to the inner sections.
12. Fit the rocker arms as shown in fig. 1 pos. 13 + 14 (pos. 13 being the
wide top part) and join the outer section to the inner section with them.
Secure all pins with split pins.
13. Mount all hydraulic hoses, components and fittings as shown in the
hydraulic diagram at the back of the book.
It is very important that the hydraulic circuit is fitted according to
the diagram, as the system contains several safety components.
Operating the roller without these components can result in personal
injury and mechanical damage.
14. Operate the large rams so that the roller tips into working position. This
allows the wheels to be fitted without using a jack.
15. Fit the wheels.
Remember to tighten them properly.
16. Lift the drawbar and fit the jack. Unscrew it until the drawplate is
approx. 45 cm above the ground.
17. Tip the roller up with the large rams.
Not too quickly or the roller will tip over backwards.
If the hydraulics have been connected correctly, the restricted flow
will ensure that these operations cannot be carried out too quickly.
18. Fit the roller rings on all side sections. Use an
8
approved crane which can lift min. 1000 kg.
roller rings with an approved strap/chain. As shown
in fig. 2.
Guide the rings into place on the roller and tighten
up properly.
Hide quick links:
Advertisement
Table of Contents
